Applications: Wide variety of agri-duty and industrial applications.

Features: Ball bearings, lubricated with high temperature moisture-resistant grease. Condensation drains, gasketed cast conduit boxes. Farm duty epoxy paint for protection from harsh environments. 1.00 Service Factor.

Three Phase - Air Over - TEAO, Rigid Base

Applications: "In the Airstream" and fan-on-shaft applications.

Features: Locked drive end bearing construction, bearings sized for larger

overhung loads for fan-on-shaft applications. 36" Leads.

Single and Three Phase - Grain Dryer/Centrifugal Fan - ODP and TEFC, Rigid Base

Applications: High pressure grain drying and storage for commercial and farm applications.

Features: Shaft length is 1" longer than NEMA standard. Screens to protect against entry of trash, snakes and rodents. Three phase ratings meet EPAct efficiencies.

Applications: Vane axial fan crop dryers.

Features: Shaft 3/4" longer than NEMA standard, shaft keyed, drilled and

tapped with internal 1/4-20 tap 1" deep. 1.00 Service Factor. Thermostats.

Epoxy paint.

Applications: Specifically engineered for use on vane axial fan crop dryers.

Features: TEAO design prevents entrance of rodents, insects and other foreign matter. High full load efficiency for reduced operating cost. No mechanical switch to wear. No noise and vibration from regeneration. Less sensitive to voltage variations. Soft start. Thermostats. Epoxy paint. 1.00 Service Factor.

Applications: Irrigation tower drive motors.

Features: Sealed fit at endplates. Sheds water. Conduit box cast into front endplate. Epoxy paint. High overload capabilities. The "P" indicates less pulley endplate for integral mounting; can be field modified for older designs with internal thru bolts.

Applications: Poultry feed auger drive systems.

Mechanical Features: Mechanical protection of centrifugal switch to prevent damage to motor in case of overspeed. Manual reset thermal protection mounted in oversize conduit box. Farm Duty epoxy paint and thermal cover protect motor from harsh environments. Extended shaft (fan end) with wrench flats for manual jogging of auger. NEMA 56N flange connects to the drive/gear box assembly. Gear reducer is assembled

to motor.

Electrical Features: High efficiency design. Moisture resistant 200°C copper windings. Stator and steel frame dipped and baked in 100% solid polyester non-hygroscopic varnish. Heavy duty Type 1 capacitor.

Applications: Inside bin grain stirring systems.

Features: Corrosion resistant epoxy finish, slotted fan cover designed to prevent clogging. Manual thermal with cover.

3/4 thru 2 Hp NEMA 56 thru 184

Applications: Farm applications such as barn cleaners, bulk feeders and industrial applications.

Features: Farm Duty epoxy paint protects motor from harsh environments. Manual thermal with cover mounted in conduit box for protection, ball bearings, condensation drains, heavy gauge steel construction.

3/4 thru 3 Hp NEMA 56 thru 145TZ

Applications: Aeration fans for farm grain storage, exhaust fans, air handling

systems, etc.

Features: Lubrication fittings on NEMA T frames for easy on-site maintenance, ball bearings,corrosion protected with epoxy finish. Normally closed thermostats on three phase motors.

Applications: Vacuum pumps used in the dairy industry.

Features: Manual thermal overload protected, heavy gauge steel frame. 

1.15 Service Factor. 50°C ambient-continuous duty. Farm duty epoxy paint.